How to configure default vlan to other vlans will communicate each other

CLELUQMAN has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Hi.
Inside the Policy>Access Control> Application Control.
Add a new policy , define your source and destination zone.
Is this answer helpful?
CLELUQMAN Lv4Posted 2023-Jan-25 16:50
  
Hi.
Inside the Policy>Access Control> Application Control.
Add a new policy , define your source and destination zone.
Farina Ahmed Lv5Posted 2023-Jan-25 17:26
  
By default VLAN is called VLAN1 and you don't need any configuration to communicate VLAN1 OR Native VLAN  to other VLANs But if still the case and it required intervlan routing then the configuration will be the same as for other VLANs communication.
RegiBoy Lv5Posted 2023-Jan-25 22:09
  
You just configure a trunk port then allow what vlans you desire.
rivsy Lv5Posted 2023-Jan-26 14:53
  
You can check in the "Policies" tab under "Application Control"
Luih Miranda Lv3Posted 2023-Jan-27 00:55
  
Vlan is a broadcast domain . By default hosts in single Vlan communicates to each other . But host in different Vlans won't communicate to each other , to ensure communication between different Vlans host routing between Vlans is mandatory for Configuring routing between Vlan layer3 device is required
Jhazz Lv3Posted 2023-Jan-27 11:16
  
You can configure it in the "Application Control" you can set it manually
Newbie517762 Lv5Posted 2023-Jan-30 10:14
  
Thanks for your sharing !

I Can Help:

Change

Moderator on This Board

11
8
5

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
139
3

Started Topics

Followers

Follow

Board Leaders