uses temporary ip in first setting and replaces it when it will be use

Newbie318663 Lv2Posted 27 Dec 2022 12:12

I just finished installing a new Sangfor HCI, if I want to set the cluster setting, add nodes and other settings using a temporary ip first, then when it will be used in data center and there is already actual ip, I replace the ip settings with the actual ip, can I do that?

Jhazz has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Yes it can be configure that way but it is much recommended to configure that IP while on connected to the network to lessen the work
Is this answer helpful?
CyberDaeng Lv1Posted 07 Jan 2023 11:35
  
Its do able, but my suggestion is to do the configuration directly with production IPs. Cause changing it, you will need to redo the network
jetjetd Lv5Posted 04 Jan 2023 14:10
  
my recommendation is to have a plan of your IP first to avoid unnecessary changes if your set up is done already to avoid inconvenience.
Josepina31 Lv2Posted 03 Jan 2023 20:31
  
it is not recommended.
RobertonY Lv2Posted 03 Jan 2023 20:25
  
Yes you can use you temporary IP
Naomi Lv3Posted 03 Jan 2023 20:18
  
Yes it is possible.
MarioC Lv2Posted 03 Jan 2023 20:17
  
While change the IP, it is recommended by the sequence below (in condition of you have 2 nodes) for easier configuration.
Lilia Lv2Posted 03 Jan 2023 20:07
  
yes it is not impossible.
Cesar Lv2Posted 03 Jan 2023 20:01
  
the whole configuration that you set will be apply after you reset.
CptArmando Lv2Posted 03 Jan 2023 19:55
  
yes it is possible but not recommended.
Farina Ahmed Lv5Posted 03 Jan 2023 18:16
  
Not recommended but possible yes.

I Can Help:

Change

Moderator on This Board

2
20
0

Started Topics

Followers

Follow

Board Leaders