Bandwidth Management Policy not Working

Asad Mirza Lv1Posted 08 Dec 2022 14:43

Hi Concern,

I have a NGAF firewall M5200 and Firmware 8.0.47. I configured the bandwidth management policy on a specific user but when i am checking on speedtest its not working. Kindly suggest how to troubleshoot. The user's traffic go through firewall confirmed by trace result.
newbie9090 Lv2Posted 08 Dec 2022 14:54

Have you set link setting/link policy at bandwidth management module?

Khawar Lv1Posted 08 Dec 2022 15:27
Great sharing.
Asad Mirza Lv1Posted 08 Dec 2022 15:36
Hi Newbie9090

Yes, before bandwidth channel configuration, first I configure this line settings.


I have two ISPs for internet but i want specific IP traffic can reached internet with specific ISP with 3 mb Guarantee Bandwidth. Is there required to set both ISPs line because I set only line 1 for ISP1 select it in bandwidth channel policy. Further I set Link bandwidth on both WAN interface accordingly.
jetjetd Lv5Posted 08 Dec 2022 19:25
If there is a default built in policy, try to remove it.
jbbertt Lv1Posted 09 Dec 2022 09:29
Hi, if all given solution was not able to solve, you can try to specify the IP of endpoint you want to manage.
Asad Mirza Lv1Posted 13 Dec 2022 18:16
Hi All,

thanks to all of you for your time to resolve this issue. Inshort the conclusion was that I handover the NGAF to the principle and I think there is any bug in programming so the firewall is in RND case. Once again thanks all of you.