IAM Vlan interfaces with Cisco Switch

syedjahanzaib Lv1Posted 2022-Nov-30 17:17

I want to connect IAM with my existing cisco switch which have different vlans for users. should I configure switch port role to  TRUNK which is connected with IAM, & where to add sub-interfaces in IAM? or whats they way forward?

Sami has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Dear Jahahzaib,

I want to connect IAM with my existing cisco switch which have different vlans for users. should I configure switch port role to  TRUNK which is connected with IAM, & where to add sub-interfaces in IAM? or whats they way forward?

Below is the format for LAN side Trunk,
VLAN TAG NO/IP_ADRR/SUBNET_MASK
E.g: 20/192.168.20.1/255.255.255.0

I hope it helps.
Is this answer helpful?
RegiBoy Lv5Posted 2022-Nov-30 18:23
  
If your Cisco Switch is your Core Switch, you can configure a trunk port on Cisco Switch to IAM so that it can see all the Vlan. The trunk port must allow all your existing vlan. Then the IAM is connected to the firewall for the uplink of the end users. The high level view of topology is Firewall>IAG>Switch
syedjahanzaib Lv1Posted 2022-Nov-30 18:34
  
IAM is connected to Cisco Core Switch where all VLANs are configured. IAM ip is 192.168.10.1 which is on VLAN-1, Users ip is 10.10.10.10 which is connected with VLAN-10 . after adding routes at user/iam, BOTH can ping each other. I have made changes to switch port where IAM is connected and set it to TRUNK. is there any thing else that needs to be configured? what default gateway should be added for user in dhcp ? at user end when i run traceroute to 1.1.1.1 , it shows destination host unreachable on 2nd hop.
jetjetd Lv5Posted 2022-Nov-30 22:05
  
Try to add some policy from IAM's network going to VLANs and vice versa and see if it will works.
MISMDS Lv3Posted 2022-Nov-30 23:15
  
Yes you should configure a trunk port going to IAM
rivsy Lv5Posted 2022-Dec-01 08:14
  
Just make a "Trunk port" in the CISCO switch then configure the IP of both CISCO and IAM
LucyHeart Lv3Posted 2022-Dec-01 08:56
  
If your IAM is your new routing device, you should reconfigure all including re addressing
Happpy Lv3Posted 2022-Dec-01 09:13
  
Please contact support team
Maqsood9090 Lv1Posted 2022-Dec-01 12:11
  
very nice post

I Can Help:

Change

Moderator on This Board

1
3
6

Started Topics

Followers

Follow

Board Leaders