NGAF 8.0.26 Sub-Interface and Bandwidth Management

Newbie572077 Lv1Posted 24 Mar 2021 18:19

Hi,

I have connected my ISP device directly to NGAF eth2 and it requires PPPoE over VLAN 500. I have configured using a sub-interface eth2.500 and the internet works fine. Since the WAN attribute follows its physical interface, I have enabled the WAN attribute on the physical interface eth2.

When it comes to bandwidth management, I am not able to choose the eth2.500 from the line channel. Only physical interfaces with WAN attribute are listed.

Can bandwidth management supports sub-interface?

By solving this question, you may help 314 user(s).

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

I Can Help:

Change

Moderator on This Board

1
35
3

Started Topics

Followers

Follow

Board Leaders