If i use Virtual Wire setup, can i still monitor and block source objects?

Newbie344490 Lv1Posted Oct-12-2020 10:19

If i use Virtual Wire setup, can i still monitor and block source objects/network? thanks

By solving this question, you may help 955 user(s).

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

KY Lv3Posted Oct-15-2020 14:27
  
May I know what product you referring? If you are using NGAF and deploy in virtual wire mode, then the access control still support in the deployment mode
Ellechar Lv4Posted Jan-08-2021 10:53
  
Very Nice Information
Newbie623281 Lv1Posted Feb-20-2021 05:41
  
im also looking for this solution.
Faisal Posted Apr-22-2021 11:36
  
Last edited by Faisal P 21 Jul 2022 14:26.

You can set the specific user or IP address in the Objects pane. See the following figure.

This topic contains more resources

You must log in to download or view the file. Not registered yet? Register

x
Fida_Balti Lv4Posted Sep-24-2021 12:40
  
Very informative ...
Fida_Balti Lv4Posted Sep-24-2021 13:34
  
Very Nice Information
Sami Lv1Posted Oct-02-2021 06:11
  
Dear Sir,

Yes you can control traffic in VW mode, from two ports (LAN<-->WAN) or Second VW Group (LAN<-->DMZ).
It works based on Physical port pairs.

Thanks & regards
ANNAL Posted May-26-2022 05:17
  
I've been looking for some nice stuff regarding the matter and haven't had any karma up until this point,

kmrnliaqat Lv3Posted Jun-01-2022 18:23
  
informative ..

I Can Help:

Change

Moderator on This Board

43
6
2

Started Topics

Followers

Follow

1
148
3

Started Topics

Followers

Follow

910
182
94

Started Topics

Followers

Follow

Board Leaders