Why bandwidth not going out 1 line?

haiha298 Lv1Posted 28 Dec 2019 12:59

i have 2 line WAN port: 1 line via eth0 ( manage port ), 1 line via eth2.
I setup bandwidth manamagement width line 1 is eth0, line 2 is line 2.
But my bandwidth goingout only 1 line is line 2 (eth2).
Can you help me an advice?
fw2.png
fw1.png

By solving this question, you may help 707 user(s).

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Park Bo Gart Lv2Posted 31 Dec 2019 03:58
  
Kindly check the following:
1. Virtual Line Rule for Line1 and Line2. Specifically the destination network configuration.
2. If there is PBR Load Balancing, check the load balancing mode and other parameters like destination network.
kmrnliaqat Lv3Posted 19 Aug 2022 14:48
  


Thank you very much for the information

I Can Help:

Change

Moderator on This Board

1
128
3

Started Topics

Followers

Follow

17
6
0

Started Topics

Followers

Follow

Board Leaders