InterVLAN Routing in Sangfor

Newbie380371 Lv1Posted 30 Aug 2019 17:01

Hello guys!

How do you implement InterVLAN routing on Sangfor?

If you can do some step-by-step configuration, I would really appreciate it.

Thanks!

By solving this question, you may help 707 user(s).

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

yakubi Lv3Posted 02 Sep 2019 12:58
  
Hi. What product?
ITD_Mitch Lv3Posted 12 Sep 2019 15:33
  
There are 2 ways..

1. If the VLAN is routed in Core Switch, you can just add static route for all your VLAN's subnet to Core Switch Default VLAN.

2. If you want to route the VLAN to Sangfor NGAF, just go to Network> Interfaces> Sub-Interface. then input all the details needed.

Thanks!
Erickson Santos Lv1Posted 14 Oct 2019 15:35
  
There are 2 ways that I know also.

1. Using Layer 3 (Route) Interface. Create mutiple sub-interfaces under 1 LAN layer 3 interface and assign corresponding VLAN number.

2. Using Layer 2 (Bridge) Interface. Create layer 2 (bridge) interface and set the link type to TRUNK and set the allowed VLAN (e.g. vlan 2-10). Then create VLAN interfaces, set ip addresses and vlan number.

Using these two options, there will be no routing needed as the VLANs will be directly connected to each other.
Hein Soe Lv1Posted 08 Jan 2020 14:28
  
314525e156cbfbb3cf.png

I created 8 VLAN at Sangfor NGAF. some of the department VLAN can ping each others and some of them can't ping another Department VLAN. Normally at Sangfor NGAF created VLAN can ping each other.

How to configure at Sangfor NGAF
Suwat Prayprun Lv2Posted 08 Jan 2020 16:19
  

I Can Help:

Change

Moderator on This Board

1
128
3

Started Topics

Followers

Follow

17
6
0

Started Topics

Followers

Follow

Board Leaders