Interface in NGAF

Newbie628265 Lv1Posted 26 Mar 2024 13:35

Which of the following descriptions best characterizes the interface utilized in NGAF?


1. There is only a method in Link State Detection, which is PING method.
2. Layer 3 interface allows PING by default.
3. Virtual wire interface fcan only add to Virtual Wire zone.
4. VLAN interface can only add to Bridge zone.

Newbie517762 has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Layer 3 interfaces in NGAF have an IP address and subnet mask to communicate with devices on the same network. They are set to allow ICMP traffic by default, including the PING command.
This allows you to test connectivity without additional configurations.

Therefore, option 2 is the best choice.
Is this answer helpful?
Newbie517762 Lv5Posted 28 Mar 2024 16:56
  
Layer 3 interfaces in NGAF have an IP address and subnet mask to communicate with devices on the same network. They are set to allow ICMP traffic by default, including the PING command.
This allows you to test connectivity without additional configurations.

Therefore, option 2 is the best choice.
Newbie389955 Lv1Posted 01 Apr 2024 10:47
  
Option 2. It allows you to test if you have access to the internet.

I Can Help:

Change

Moderator on This Board

1
131
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders