HCI upgrade

rkay Lv1Posted 01 Feb 2024 10:01

Have anyone successfully upgraded from Hyper-Converged Infrastructure 6.8.0_R1 to Hyper-Converged Infrastructure 6.8.0_R2?

AimanHakim has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Last edited by AimanHakim 01 Feb 2024 11:36.

Based on the release note, it should support hot direct upgrade 6.8.0R1 > 6.8.0.R2. You can also check using Sangfor aDeploy tool to do a pre-check upgrade. It will also show you the upgrade sequence too.

In case during the pre-upgrade check failed, an error will pop up showing what is the cause of failure. In case of abnormalities, the error pop up will notify you to cantact sangfor tecg team since it may require to troubleshoot directly into the backend system.
Is this answer helpful?
AimanHakim Lv2Posted 01 Feb 2024 11:35
  
Last edited by AimanHakim 01 Feb 2024 11:36.

Based on the release note, it should support hot direct upgrade 6.8.0R1 > 6.8.0.R2. You can also check using Sangfor aDeploy tool to do a pre-check upgrade. It will also show you the upgrade sequence too.

In case during the pre-upgrade check failed, an error will pop up showing what is the cause of failure. In case of abnormalities, the error pop up will notify you to cantact sangfor tecg team since it may require to troubleshoot directly into the backend system.

I Can Help:

Change

Moderator on This Board

2
20
0

Started Topics

Followers

Follow

Board Leaders