Aggregated Physical Interface: Which Physical Port Does the Traffic Goes

eddychong Lv1Posted 21 May 2018 17:39

Hi,

We did aggregation for our management interface/VM Network. Is there a way we can see the traffic actually sending or receiving from which physical ports under the same aggregation group?

Thank you
Eddy

CTI LS has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Hi Eddy,

You may filter and check the port traffic from the following path:
Nodes > Select the Nodes you would like to check > Filter the Interface that you would like to check
1.jpg
Is this answer helpful?
CTI LS Lv3Posted 21 May 2018 17:49
  
Hi Eddy,

You may filter and check the port traffic from the following path:
Nodes > Select the Nodes you would like to check > Filter the Interface that you would like to check
1.jpg
eddychong Lv1Posted 21 May 2018 18:09
  
I wonder we can check it through the CLI? Can we SSH to the host using admin account? I tried, it seems like that admin account can only login to the web console.
CTI LS Lv3Posted 22 May 2018 09:33
  
Hi Eddy,

Unfortunately the SSH is only allowed for internal staff only. Therefore currently it is not allow to login to CLI.

I Can Help:

Change

Moderator on This Board

2
20
0

Started Topics

Followers

Follow

Board Leaders