mdamores Lv3Posted 05 Mar 2024 11:39
  
Go to Basic Settings > VPN Paths > +Add and see if +Add is Active. If not, this could be due to several reasons. You may check some troubleshooting guides below:

1. Check if your user account has administrative privileges to configure VPN paths. You credentials should have permission to add new paths
2. Check if your current license covers the number of desired VPN paths. As you mentioned, 10 branch VPN sites 10 lines so make sure that your license can accommodation those numbers
3. Validate if the interface you intend to use for VPN path is properly configured and enabled on Sangfor NGAF device to be selectable for VPN path creation
4. The version is quite updated but check for possible bugs or limitations of your current version. You may refer to  Sangfor official documentation for additional reference.

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
0
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders