Zonger Lv4Posted 05 Mar 2024 20:19
  
To activate the interface selection in Basic Settings > VPN Paths > +Add on your NGAF (High Availability) with the given license and version, follow these steps:

1. Ensure that both NGAF devices are running the same version (8.0.47) and have the latest firmware updates installed.
2. Check if the interfaces you want to use for VPN paths are in an up and operational state. If not, bring them up using the appropriate interface configuration commands.
3. Make sure that the interfaces you want to use for VPN paths are not in the same subnet as the management interface of the NGAF. This is a common restriction in the system configuration.
4. Verify that the interfaces you want to use for VPN paths are not already configured as the primary or secondary interfaces in the system settings.
5. If none of the above steps resolve the issue, try resetting the web GUI configuration of your NGAF devices. This can be done through the CLI using the command "reset config" or by accessing the web GUI and navigating to System > Backup & Restore > Reset Configuration.

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
0
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders