Enrico Vanzetto Lv3Posted 20 Feb 2024 16:01
  
Hi, if you are unable to access the Sangfor IAG (Internet Access Gateway) web UI because you don’t know the IP address, here are some troubleshooting steps you can try:

Check Other Ports for Management IP:
Use the Sangfor Firmware Updater to check other ports of the NGAF (Next-Generation Application Firewall) for management IP addresses.
If you find an IP address associated with a different port, try accessing the web UI using that IP.
Additionally, ping the management IP to verify connectivity.
If you can ping, attempt to telnet to the IP using port 443.

Sub-IP Addresses:
Similar to the IAM device, NGAF might have sub-IP addresses on different ports (e.g., ETH0, ETH1).
Verify if there are sub-IP addresses assigned to specific ports and try accessing the web UI using those.

Direct Cable Connection:
Connect directly to the NGAF using an Ethernet cable.
Configure your PC’s IP address to match the same range as the NGAF’s IP (e.g., ETH0 = 10.251.251.251).
Attempt to access the web UI.
If the connection hangs, try using Internet Explorer.

Factory Defaults Reset:
If all else fails, consider resetting the NGAF to factory defaults.
Avoid configuring the IP on a new port after accessing the web UI to prevent similar issues with other ports.

Remember to adapt these steps based on your specific NGAF configuration and network environment. If you continue to face issues, consider reaching out to Sangfor’s technical support for further assistance

I Can Help:

Change

Moderator on This Board

15
21
3

Started Topics

Followers

Follow

Board Leaders