Happpy Lv3Posted 12 Feb 2024 17:01
  
Set up SNAT on your firewall or local network device to transform outgoing packet source IP address to 192.168.77.1.
Make that the IPSec tunnel is set up correctly to permit traffic to flow from the remote network (172.17.17.9/32) to the local subnet (192.188.77.1/32).
Make that the routing is configured properly to send traffic over the IPSec tunnel that is meant for the distant subnet.
It's crucial to remember that the precise procedures for configuring SNAT over an IPSec tunnel can change based on the hardware and software you're utilizing.

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
0
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders