WAN Failover on NGAF Firewall

faizan Lv1Posted 12 Oct 2018 17:37

Hi,

I am configuring the 2 wan links on the Firewall. Does anybody guide me or share any documentation how to configure failover between  the two WAN links.

Regards,

Ver has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go


Hi,

On network interface, Click wan link


wan1.PNG

then, on the bottom click Link state Detection Settings.

wan2.PNG

Enable, then tick PING and set Destination IP 1 (input gateway IP of ISP)

wan3.PNG

After Configuring Link state detection of your Wan Links
You can see the state of it if its Normal or at Fault

wan5.PNG

After setting the link state detection, Go to Network > Routing > Policy Based Routing then add Link Load Balancing Route.
Network Objects > ALL
Then add interface of Wan Links for failover
wan4.PNG

Thanks!!
Is this answer helpful?
Ver Lv1Posted 12 Oct 2018 17:57
  

Hi,

On network interface, Click wan link


wan1.PNG

then, on the bottom click Link state Detection Settings.

wan2.PNG

Enable, then tick PING and set Destination IP 1 (input gateway IP of ISP)

wan3.PNG

After Configuring Link state detection of your Wan Links
You can see the state of it if its Normal or at Fault

wan5.PNG

After setting the link state detection, Go to Network > Routing > Policy Based Routing then add Link Load Balancing Route.
Network Objects > ALL
Then add interface of Wan Links for failover
wan4.PNG

Thanks!!

I Can Help:

Change

Moderator on This Board

1
25
3

Started Topics

Followers

Follow

Board Leaders