Fail to Recovery Password IAM

dadhityo Lv1Posted 27 Sep 2023 15:02

Hello everyone,

i already reset admin password using following method, but it does'nt work, login default admin-admin still error but login other user is work. anyone can help me? thank you

1. In browser, enter https://IAMIP/php/rp.php and the page will show "File is created. Please plug in crossover cable and restart device."
2. Plug a cable that connect to 2 interface on IAM(such as eth0-eth2,eth1-eth3).
Note that the 2 interface cannot be bypass interface(such as eth0-eth1,eth2,eth3).
3. After that, unplug any other cable that connected to IAM.
4. Restart IAM. (power offon button at back)

By solving this question, you may help 514 user(s).

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Newbie517762 Lv5Posted 29 Sep 2023 10:13
  
Hi there,

If you're still facing issues with admin login after completing the password recovery process,
you can contact Sangfor Technical Support at Tech.Support@sangfor.com for assistance.
Alternatively, you can restore the factory defaults by following these steps:

1. Power off the IAG device using the power button.
2. Prepare a crosswire or USB drive.
3. Connect the IAG device to any two interfaces using the crosswire (excluding bypass interfaces).
4. Power on the IAG device and wait for approximately 5 minutes.

I Can Help:

Change

Moderator on This Board

11
54
1

Started Topics

Followers

Follow

15
21
3

Started Topics

Followers

Follow

Board Leaders