mdamores Lv3Posted 20 Sep 2023 10:23
  
To configure pass-through mode, you would set rules or policies to specify which traffic are allowed or not. Below are some steps to configure pass-through mode in Sangfor NGAF depending on the version and configuration in each deployment.
1.        Login to Sangfor NGAF management console
2.        Check the firewall policy or rule configuration page
3.        Create rule or policy with specific policy for traffic in pass-through mode
4.        In the rule or policy configuration, make sure that the option for Pass-through mode was set to allowed or enabled.
5.        Always make sure to save and apply the configuration changes.
Please take note that while pass-through mode is useful for some cases, it reduces the security level provided by NGAF. So always make sure to use it with precaution and only when necessary

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
0
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders