mdamores Lv3Posted 04 Sep 2023 11:24
  
Last edited by mdamores 04 Sep 2023 11:34.

Hi,

you might be experiencing the user authentication and identification when integrating with Microsoft AD using SSO. you may try the troubleshooting steps below:

- check if your IAG device is integrated to your AD domain controller and verify if LDAP server address, port, and credentials are properly configured to connect with your AD and conduct testing
- validate if correct AD users are mapped to the corresponding IP addresses or devices in IAG config
- make sure that IAG device is using the correct AD and review SSO configuration settings.
- check if there are firewall rules or policies that currently blocks the communication between AD and IAG device. same thing goes for network connectivity.
- you may also consider updating the firmware since sometimes, outdated firmware can cause compatibility issues

I Can Help:

Change

Moderator on This Board

15
21
3

Started Topics

Followers

Follow

Board Leaders