Problem removing WAN Attribute

Marco Barbieri Lv1Posted 11 Sep 2018 23:15

Hi, removing next hop ip and WAN Attributo on a phisical interfce i get this error:
"Error: The interface eth0 is referenced by line definition. You cannot remove its WAN attribute!"

it is not referenced in any routing or policy based routing, where i can check?
using last version of NGAF operating system released in August.

many thanks
MArco

Ver has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Hi please check the bandwidth management > line definition and remove the eth# in the line definition
Is this answer helpful?
Ver Lv1Posted 12 Sep 2018 11:18
  
Hi please check the bandwidth management > line definition and remove the eth# in the line definition
SC Lv2Posted 12 Sep 2018 15:32
  
Hi! Marco.
Have you try Policies -> Bandwidth management -> Line Definition and remove the eth0 in your line definition.
Muhammad Talha Lv3Posted 12 Sep 2018 18:47
  
Hi,

The interface is in use. That's why you cannot change any attribute. First you need to remove all policies on this interface and then try.
Marco Barbieri Lv1Posted 18 Sep 2018 16:11
  
Hi, solved, it was bandwith management line definition, automatically configured by NGAF.

Many thanks
MArco

I Can Help:

Change

Moderator on This Board

1
129
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders