Farina Ahmed Posted 19 Jun 2023 16:53
  
To enable Web Application Firewall (WAF) on the Sangfor NGAF (Next Generation Application Firewall), you can follow these general steps:

Access the NGAF management interface: Open a web browser and enter the management IP address or hostname of your NGAF appliance.

Log in to the NGAF management console: Enter your credentials to log in as an administrator.

Navigate to the WAF configuration section: Depending on the NGAF version and interface layout, locate the WAF configuration settings. It is usually found in the "Security" or "Web Protection" section of the management console.
Enable WAF: Within the WAF configuration settings, enable the Web Application Firewall feature. There may be a checkbox or toggle switch to enable or disable WAF.

Configure WAF policies: Once WAF is enabled, you can configure WAF policies to define how NGAF should protect your web applications. This includes setting up rules, filters, and other security measures to detect and prevent common web application attacks.

Customize WAF settings: Adjust WAF settings according to your requirements. This may include specifying allowed or blocked URLs, configuring signature-based detection, adjusting security levels, and configuring logging and reporting options.

Save and apply changes: After configuring the WAF policies and settings, save the changes and apply them to make them active.

Test and monitor: Test the WAF by accessing your web applications and verifying that the desired protection measures are in place. Continuously monitor the WAF logs and reports to ensure effective protection and make necessary adjustments as needed.

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
0
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders