Zonger Lv4Posted 16 Jun 2023 04:26
  
If your hard disk is not being detected during the installation of Sangfor version 6.3.0 on your HP ProLiant DL360 Gen10 Plus server, please follow beloe steps  to troubleshoot and resolve the issue:
  • Check the physical connections: Ensure that the hard disk is properly connected to the server's storage controller. Check the cables and connections to make sure they are secure.
  • Verify server compatibility: Confirm that the HP ProLiant DL360 Gen10 Plus server is compatible with the version of Sangfor you are trying to install. Check the system requirements and compatibility matrix provided by Sangfor to ensure that your server model is supported.
  • Update firmware and drivers: Ensure that the server's firmware and storage controller drivers are up to date. Visit the HP support website and download the latest firmware and drivers for your server model. Install the updates and try the installation process again.
  • Enable RAID settings: If you are using RAID configurations on your server, access the RAID controller settings during the server boot process. Verify that the hard disk is included in the RAID configuration and that the RAID settings are properly configured.
  • Check BIOS settings: Enter the server's BIOS settings and ensure that the storage controller and hard disk settings are correctly configured. Look for any settings related to hard disk detection and compatibility and adjust them as needed.
  • Test with a different hard disk: If possible, try using a different hard disk to determine if the issue is specific to the disk or related to the server. This can help isolate the problem and identify whether the issue lies with the hard disk itself or with the server's configuration.

I Can Help:

Change

Moderator on This Board

3
1
2

Started Topics

Followers

Follow

2
0
0

Started Topics

Followers

Follow

0
0
0

Started Topics

Followers

Follow

Board Leaders