Zonger Lv5Posted 08 May 2023 18:15
  
The command mentioned, "netsh advfirewall set allprofiles state off," is used to disable the Windows Firewall for all network profiles (Domain, Private, and Public). It turns off the firewall protection, allowing all incoming and outgoing network traffic without any filtering or blocking.

However, it's important to note that disabling the Windows Firewall can expose your computer or network to potential security risks. The firewall acts as a barrier between your system and the outside network, helping to prevent unauthorized access and protecting against malicious threats.

If you choose to disable the firewall temporarily for troubleshooting purposes or other specific reasons, make sure to take appropriate precautions, such as ensuring that your computer is not directly connected to the internet or being used in an insecure network environment.

After you have completed your intended tasks, it is strongly recommended to enable the Windows Firewall or configure it to allow only necessary traffic based on your network security requirements. You can enable the firewall again using the command:

netsh advfirewall set allprofiles state on


Always prioritize the security of your system and network by implementing a comprehensive and robust security strategy.
Imran Tahir Lv4Posted 08 May 2023 21:53
  
Get help with technical support
Pat Lv4Posted 09 May 2023 06:55
  
In some cases, however, an EDR solution may detect that a firewall is causing issues with network connectivity or other system functions. In such cases, the EDR solution may recommend disabling the firewall temporarily to troubleshoot the issue. However, this would typically be done with the explicit knowledge and consent of the system administrator or other responsible parties, and only as a temporary measure until the issue can be resolved.
eram Lv1Posted 09 May 2023 07:19
  
A recent software update or system configuration change could have caused the EDR agent and firewall to stop working correctly. Sometimes updates or changes to your system can inadvertently cause conflicts with security software and result in malfunctions.
Franky Lv3Posted 09 May 2023 08:36
  
However, an EDR solution may detect that a firewall is interfering with network access or other system functions in some cases.
Gomu Lv2Posted 09 May 2023 08:40
  
it indicate that it detects a malware.
CLELUQMAN Lv3Posted 09 May 2023 09:12
  
have u solve this? i think the EDR turn off the firewall is temporary , maybe it is updating or scanning.

I Can Help:

Change

Moderator on This Board

3
8
3

Started Topics

Followers

Follow

43
2
2

Started Topics

Followers

Follow

1
1
5

Started Topics

Followers

Follow

7
11
4

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Trending Topics

Board Leaders