The IAG 90 is a network security appliance produced by Barracuda Networks that is designed for small to medium-sized businesses. It supports multiple deployment modes, including bridge mode, which allows the IAG to operate transparently on the network.

Regarding your question, it is possible to aggregate the LAN ports and WAN ports on the IAG 90 for load balancing purposes, but it depends on the specific capabilities of the device and the network environment in which it is deployed.

Here are some general steps you can follow to aggregate the ports on the IAG 90:

1- Check if the IAG 90 supports port aggregation: You can consult the product documentation or contact Barracuda Networks support to confirm if the IAG 90 supports port aggregation.

2- Configure the LAN ports and WAN ports: In bridge mode, the IAG 90 acts as a transparent device, so you will need to configure the LAN and WAN ports separately to achieve load balancing. You can use the web interface or command-line interface to configure the ports.

3- Configure the load balancing algorithm: Once you have aggregated the ports, you will need to configure the load balancing algorithm to distribute traffic across the available ports. The IAG 90 may support different algorithms, such as round-robin or weighted round-robin.

4- Test the configuration: Once you have completed the configuration, it is essential to test the load balancing to ensure that it is working as expected. You can use a network testing tool or monitor the network traffic to verify the load balancing.

It is essential to note that the specific steps and configuration options may vary depending on the IAG 90 model and firmware version. Therefore, it is recommended to consult the product documentation or contact Barracuda Networks support for detailed instructions and guidance.

The IAG 90 is a network security appliance produced by Barracuda Networks that is designed for small to medium-sized businesses. It supports multiple deployment modes, including bridge mode, which allows the IAG to operate transparently on the network.

Regarding your question, it is possible to aggregate the LAN ports and WAN ports on the IAG 90 for load balancing purposes, but it depends on the specific capabilities of the device and the network environment in which it is deployed.

Here are some general steps you can follow to aggregate the ports on the IAG 90:

1- Check if the IAG 90 supports port aggregation: You can consult the product documentation or contact Barracuda Networks support to confirm if the IAG 90 supports port aggregation.

2- Configure the LAN ports and WAN ports: In bridge mode, the IAG 90 acts as a transparent device, so you will need to configure the LAN and WAN ports separately to achieve load balancing. You can use the web interface or command-line interface to configure the ports.

3- Configure the load balancing algorithm: Once you have aggregated the ports, you will need to configure the load balancing algorithm to distribute traffic across the available ports. The IAG 90 may support different algorithms, such as round-robin or weighted round-robin.

4- Test the configuration: Once you have completed the configuration, it is essential to test the load balancing to ensure that it is working as expected. You can use a network testing tool or monitor the network traffic to verify the load balancing.

It is essential to note that the specific steps and configuration options may vary depending on the IAG 90 model and firmware version. Therefore, it is recommended to consult the product documentation or contact Barracuda Networks support for detailed instructions and guidance.