NGAF - How to enable Netflow?

FahmiAzlanMY Lv1Posted 26 Jan 2023 11:35

Hi,

I have NGAF version 8.0.47, may I know how to configure NetFlow?

Thanks

VanFlyheights has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

as per documentation, it is not supported yet
Is this answer helpful?
Farina Ahmed Lv5Posted 26 Jan 2023 13:44
  
It is not specifically shown for NGAF but you can follow these steps for NGAF. Configuration might vary a little bit from this but check NGAF GUI and do accordingly. I am sharing link for Palo Alto.

https://knowledgebase.paloaltone ... =kA10g000000ClJzCAK
rivsy Lv5Posted 27 Jan 2023 13:55
  
Maybe will wait for the official Netflow configuration from Sangfor since it does not have right now
Jhazz Lv3Posted 27 Jan 2023 14:00
  
Upon researching and reviewing the sangfor knowledge base site, there is no manual on the configuration guide for Netflow. You may seek help to your local sangfor provider for assistant right now. Since Netflow configuration and command is different from each brand and model (you cannot use the Netflow configuration guide for CISCO, HP and others).

NetFlow is based on 7 key fields:
1. Source IP address
2. Destination IP address
3. Source port number
4. Destination port number
5. Layer 3 protocol type (ex. TCP, UDP)
6. ToS (type of service) byte
7. Input logical interface
FahmiAzlanMY Lv1Posted 27 Jan 2023 14:33
  
Last edited by FahmiAzlanMY 27 Jan 2023 16:54.

Thanks guys, I have contact support, they said netflow doesn't support at the moment.
There is no any roadmap for this.
RegiBoy Lv5Posted 27 Jan 2023 14:35
  
Netflow is for Cisco only because it is proprietary. Maybe it is SFLOW.
Naomi Posted 27 Jan 2023 16:35
  
No documentation for netflow
BitCloud Lv3Posted 27 Jan 2023 16:50
  
NetFlow is based on 7 key fields:
1. Source IP address
2. Destination IP address
3. Source port number
4. Destination port number
5. Layer 3 protocol type (ex. TCP, UDP)
6. ToS (type of service) byte
7. Input logical interface
Natsu Dragneel Lv3Posted 27 Jan 2023 16:53
  
It is not supported yet.
VanFlyheights Lv3Posted 27 Jan 2023 16:55
  
as per documentation, it is not supported yet

I Can Help:

Change

Moderator on This Board

11
7
5

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
137
3

Started Topics

Followers

Follow

Board Leaders