Sangfor Community»Categories Product aCloud (HCI) uses temporary ip in first setting and replaces it w ...

uses temporary ip in first setting and replaces it when it will be use

views: 6108 | comments: 17 | added to Favorites 0
Lights on | 提示:支持键盘翻页<-左 右->
    组图打开中,请稍候......
Created: 27 Dec 2022 12:12

Summary:

I just finished installing a new Sangfor HCI, if I want to set the cluster setting, add nodes and other settings using a temporary ip first, then when it will be used in data center and there is alrea ...

Reply

CyberDaeng Posted 07 Jan 2023 11:35
Its do able, but my suggestion is to do the configuration directly with production IPs. Cause changing it, you will need to redo the network
jetjetd Posted 04 Jan 2023 14:10
my recommendation is to have a plan of your IP first to avoid unnecessary changes if your set up is done already to avoid inconvenience.
Josepina31 Posted 03 Jan 2023 20:31
it is not recommended.
RobertonY Posted 03 Jan 2023 20:25
Yes you can use you temporary IP
Naomi Posted 03 Jan 2023 20:18
Yes it is possible.
MarioC Posted 03 Jan 2023 20:17
While change the IP, it is recommended by the sequence below (in condition of you have 2 nodes) for easier configuration.
Lilia Posted 03 Jan 2023 20:07
yes it is not impossible.
Cesar Posted 03 Jan 2023 20:01
the whole configuration that you set will be apply after you reset.
CptArmando Posted 03 Jan 2023 19:55
yes it is possible but not recommended.
Farina Ahmed Posted 03 Jan 2023 18:16
Not recommended but possible yes.
Jhazz Posted 27 Dec 2022 20:53
Yes it can be configure that way but it is much recommended to configure that IP while on connected to the network to lessen the work