jetjetd Lv5Posted 06 Dec 2022 21:27
  
Bypass Mirror Interface Configuration Bypass mode: A network environment does not need to be modified to implementprotection. The risk of network interruption caused by device malfunction can be avoided. TheNGAF is connected to the mirror interface of a switch or to a hub so that an Internet useraccesses the data of a server through the switch or hub. Upstream and downstream data must bemirrored when the mirror interface is configured to realize server protection.
Kindly check screenshots below. if this is can be seen in vNGAF:





In bypass mode, set the source and destination zones to the zone which the bypass mirrorinterface belongs to, and set the destination IP address group to the IP address group which theserver network segment belongs to.Step 6: Connect the NGAF to the network, interface ETH1 to the bypass mirror interface of thelayer 3 switch, and interface ETH0 to an interface of VLAN99 of the layer 3 switch on the intranet.


I Can Help:

Change

Moderator on This Board

1
131
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders