Not all types of interfaces shown 5

imsfckw Posted 05 Dec 2022 21:42

Hi all! There's only 3 types of interfaces (Layer 3, Layer 2 and Virtual Wire) on my vNGAF 8.0.47 but i need Mirror mode. Is it possible to set up mirror interface on virtual NGAF?

Happpy has solved this question and earned 25 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins, 5 coins of bounty and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Virtual NGAF is not supported
Is this answer helpful?
RegiBoy Lv5Posted 06 Dec 2022 16:29
  
It is not possible to setup an mirror interface on the NGAF unless it is set to Mirror Mode.
Newbie517762 Lv5Posted 06 Dec 2022 17:35
  
HiHi,

vNGAF is a Distributed Firewall, pls find below linking for your easy Ref:
jetjetd Lv5Posted 06 Dec 2022 21:27
  
Bypass Mirror Interface Configuration Bypass mode: A network environment does not need to be modified to implementprotection. The risk of network interruption caused by device malfunction can be avoided. TheNGAF is connected to the mirror interface of a switch or to a hub so that an Internet useraccesses the data of a server through the switch or hub. Upstream and downstream data must bemirrored when the mirror interface is configured to realize server protection.
Kindly check screenshots below. if this is can be seen in vNGAF:





In bypass mode, set the source and destination zones to the zone which the bypass mirrorinterface belongs to, and set the destination IP address group to the IP address group which theserver network segment belongs to.Step 6: Connect the NGAF to the network, interface ETH1 to the bypass mirror interface of thelayer 3 switch, and interface ETH0 to an interface of VLAN99 of the layer 3 switch on the intranet.


rivsy Lv5Posted 07 Dec 2022 08:45
  
Yes you can mirror it just select "Mirror" in the "Route" then fill up the rest of the tab
Happpy Lv3Posted 12 Dec 2022 09:59
  
Virtual NGAF is not supported
Naomi Lv3Posted 12 Dec 2022 10:02
  
Pysical Appliance is required when using Mirror Mode
Rhebie Lv3Posted 12 Dec 2022 10:10
  
Yes you can mirror it just select "Mirror" in the "Route" then fill up the rest of the tab
Rashley Lv2Posted 12 Dec 2022 10:18
  
Physical Appliance is required when using Mirror Mode
Robin Lv3Posted 12 Dec 2022 10:26
  
Virtual is not supporting the Mirror Mode.

I Can Help:

Change

Moderator on This Board

1
130
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders