Sangfor Community»Categories Product Internet Access Gateway (IAG) Bandwidth usage mismatch with virtual line

Bandwidth usage mismatch with virtual line

views: 7069 | comments: 21 | added to Favorites 0
Lights on | 提示:支持键盘翻页<-左 右->
    组图打开中,请稍候......
Created: 16 Nov 2022 10:48

Summary:

Hello, i have IAM 5200 with OS 13.0.19 i have a problem with our internet link, we have 70Mbps connection but when i check on sangfor it only limit to 60Mbps. Virtual line config on bandwidth managem ...

Reply

Faisal P Posted 27 Nov 2022 23:25
IAM has a sub-IP address on ETH0 (128.127.125.252/29)
sumran Posted 25 Nov 2022 12:38
please disable the band width feature then it works
CTI_JianJie Posted 24 Nov 2022 11:37
Hi Denny, could you try to disable the bandwidth management policy to see if the bandwidth could be improved over 60Mbps? If not, you can try to enable passthrough mode to prevent the data flow is being restricted by the Sangfor IAM policy.
Farina Ahmed Posted 22 Nov 2022 14:11
70 Mbps doesn't means that you will get full MBs, there are slight variation acceptable and also there are uploading/downloading MBs in this full scenarios but you can ask your ISP, he will clarify it more.
arjay Posted 22 Nov 2022 12:15
Sangfor IAG's output is accurate. You must check it with your ISP Provider
jetjetd Posted 21 Nov 2022 23:47
Try to set the Inbound and Outbound bandwidth to unlimited and see what is the result.
Imran Tahir Posted 21 Nov 2022 12:51
In wifi bandwidth decreased
kmrnliaqat Posted 21 Nov 2022 12:32
In wifi some decrease of bandwitdh

MISMDS Posted 21 Nov 2022 11:43
You config is good and don't change it
grayice499 Posted 21 Nov 2022 11:32
ISPs are the dependent on that issues.
rivsy Posted 21 Nov 2022 10:20
There are 2 factors:
1. Type of connection either LAN or WIFI, usually WIFI connection decrease bandwidth
2. The ISP provided bandwidth is "up to", means it is not 100% they only give 80 to 90 percent of bandwidth