damulagski Lv3Posted 20 Oct 2022 16:45
  
f your setting is simply a basic configuration, you can use the GUI
babeshuka Lv3Posted 20 Oct 2022 16:50
  
Use GUI instead
Happpy Lv3Posted 20 Oct 2022 16:56
  
setting is simply a basic configuration
grayice499 Lv2Posted 20 Oct 2022 16:59
  
Click the Launch NAT Wizard button. Follow the wizard prompts. The upper-left area of the wizard page shows where you are in the configuration process.
nobitachou Lv2Posted 21 Oct 2022 11:02
  
use in your Juniper setup?
You can use the Wizard
soneosansan Lv3Posted 21 Oct 2022 11:05
  
rule-set rs-DA {
                from zone DC-A ;
                to zone internet;
                rule DNS-4-source-nat-rule {
                    match {
                        source-address 10.252.252.4/32;
LucyHeart Lv3Posted 21 Oct 2022 11:08
  
  security-zone DC-A  {
            address-book {
                address dashborad-svr 10.252.252.17/32;
                address dns00-svr 10.252.252.4/32;
                address dns01-svr 10.252.252.5/32;
                address idea-svr 10.252.252.30/32;
                address idea-web2-svr 10.252.252.31/32;
                address idea-web1-svr 10.252.252.32/32;
                address pjj-svr 10.252.252.34/32;
                address hosting-svr 10.252.252.98/32;
                                }
Jigen87 Lv3Posted 21 Oct 2022 11:12
  
would be easier if you will do it in Juniper's GUI.
Fuji12 Lv3Posted 21 Oct 2022 11:16
  
nat {
        source {
            pool public-out-dns-server-4 {
                address {
                    103.x.x.x/32;
                }
            }
MISMIS Lv3Posted 21 Oct 2022 11:20
  
GUI is enough is basic configuration is done

I Can Help:

Change

Moderator on This Board

1
130
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders