Franky Lv3Posted 19 Oct 2022 12:08
  
use the Wizard if your configuration is just a basic config
Fisher Lv2Posted 19 Oct 2022 12:16
  
Because in Sangfor NGAF the zone just for binding to the interfaces.
Newbie098542 Posted 19 Oct 2022 12:35
  

Follow the wizard prompts.  You can use the Wizard if your configuration is just a basic configuration
Carrot Lv3Posted 19 Oct 2022 12:39
  
rule-set rs-DA {
                from zone DC-A ;
                to zone internet;
                rule DNS-4-source-nat-rule {
                    match {
                        source-address 10.252.252.4/32;
                    }
Brooker Lv3Posted 19 Oct 2022 12:50
  
Its  complicated when you use CLI instead of GUI but have almost same output
KatAndres Lv2Posted 19 Oct 2022 17:05
  
You can use the Wizard if your configuration is just a basic one.
chepadrinao Lv3Posted 19 Oct 2022 17:12
  
You can use the Wizard if your configuration is just a basic one.
Fverdillo Lv2Posted 19 Oct 2022 17:16
  
Just try to Wizard for basic configuration.
jpbaltazar Lv2Posted 20 Oct 2022 07:38
  
You may use the NAT wizard to guide you to the process
Deorwine Lv2Posted 20 Oct 2022 13:32
  
Use Wizard if you do basic configuration

I Can Help:

Change

Moderator on This Board

11
5
4

Started Topics

Followers

Follow

1
2
5

Started Topics

Followers

Follow

0
3
4

Started Topics

Followers

Follow

67
19
3

Started Topics

Followers

Follow

3
10
3

Started Topics

Followers

Follow

1
137
3

Started Topics

Followers

Follow

Board Leaders