Franky Lv3Posted 19 Oct 2022 12:08
no feature as of the moment so well just wait
Fisher Lv2Posted 19 Oct 2022 12:11
We'll have to wait and see whether Sangfor Team includes it in a later firmware release. It can currently be configured on a router provided by the ISP before the IAG device.
Carrot Lv3Posted 19 Oct 2022 12:40
Watch to see if Sangfor Team includes it in a future firmware upgrade. As of right now, it can be set up before the IAG device, just like on the router that comes with the ISP.
Newbie098542 Posted 19 Oct 2022 12:40
To configure static NAT, three steps are required:
configure private/public IP address mapping by using the ip nat inside source static PRIVATE_IP PUBLIC_IP command.
configure the router's inside interface using the ip nat inside command.
configure the router's outside interface using the ip nat outside command.
Brooker Lv3Posted 19 Oct 2022 12:46
Use Hybrid deployment of Bridge and Route Mode
chepadrinao Lv3Posted 19 Oct 2022 17:12
There is no feature as of the moment. Let's wait and see if Sangfor Team will add it to their future firmware update. As of now, It can be configured before the IAG device like on the ISP provided router.
jetjetd Lv5Posted 20 Oct 2022 02:14
You cannot configure NAT in a bridge mode.
jpbaltazar Lv2Posted 20 Oct 2022 07:42
NAT/DHCP/VPN/PBR2 are protocols that not support on bridge mode.
Deorwine Lv2Posted 20 Oct 2022 13:25
No features at this moment and according to the documentation, NAT/DHCP/VPN/PBR are not supported. We'll just have to wait.
damulagski Lv3Posted 20 Oct 2022 16:46
NAT/DHCP/VPN/PBR are not supported functions of a Bridge Mode IAG.

I Can Help:


Moderator on This Board


Started Topics



Board Leaders