Failed to integrate NGAF with ES

|
  • 123
  • 0

Issue Description

Customer wants to integrate/correlate NGAF with ES but failed with the following error "Failed to connect to Endpoint Secure. Please check whether it runs properly"

Error/Warning Information

Handling Process

1. Check whether able to access the ES management console on port 443 normally.
2. Verify when was the ES deployed because newly deployed takes time to load. It was deployed 3 weeks ago.
3. Check whether [Device Integration] is enabled on ES.

Root Cause

The [Device Integration] needs to be enabled in order to allow the access for devices integration. Otherwise, it cannot be integrated.

Solution

1. Go to [System]-[System]-[General]-[Device Integration] and enable.
2. Proceed to integrate within the configured minutes.

Suggestions

Applicable for ES version 3.2.21 and above.

I want to write a case
Doc ID: 7308
Author: Sangfor_Siva
Updated: 2022-09-21 09:58
Version: