Imran Tahir Lv4Posted 30 Jul 2022 14:17
  
You can use a cross cable to restore factory defaults except by Updater,
Steps:
1. Use the power button to shut down the IAM device.
2. Prepared a cross cable.
3. Using the cross cable to connect to any two interfaces of the IAM device。(Attention: The two interface can't be bypass interfaces.)
4. Finally starting up the IAM device and waiting for 5 minutes.
Hello have you tried the steps below?

1. Connect to NGAF with firmware updater.
2. Press F10, and choose the Restore Factory Defaults.
Is this answer helpful?
Imran Tahir Lv4Posted 01 Aug 2022 15:58
  

You can use a cross cable to restore factory defaults except by Updater,
Steps:
1. Use the power button to shut down the IAM device.
2. Prepared a cross cable.
3. Using the cross cable to connect to any two interfaces of the IAM device。(Attention: The two interface can't be bypass interfaces.)
4. Finally starting up the IAM device and waiting for 5 minutes.

I Can Help:

Change

Moderator on This Board

1
131
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders