Unable to select VM when creating DR policy

|
  • 173
  • 12

Issue Description

User wants to create a DR policy and found that the VM name is greyed out and not able to select it.
Prompting the following message when mouseover:
Please shut down the VM before changing its name. VM name can contain only a maximum of 70 characters

Error/Warning Information

Handling Process

1. Check the VM name is not over 70 character limit.
2. Has a special character '.', but it should not cause the problem.
3. VM name also has a whitespace.

Root Cause

SCP does not support VM name with whitespace.

Solution

1. Rename the VM name, removing the whitespace and replace with underscore '_'.
2. Wait a few minute and refresh SCP.
3. Able to select the VM normally when creating DR task.

Suggestions

1. Suggest not to use whitespace when naming the VM in HCI, even though HCI does not restrict.
This is because there are some limitations on the SCP.
Kashif Mughal Lv1Posted 17 Aug 2022 17:43
  
good Information
Naghmana Lv1Posted 19 Aug 2022 19:32
  
Thank you for your information
Asad Abbasi Lv1Posted 19 Aug 2022 19:51
  
Thank you for your information
Newbie698456 Lv1Posted 19 Aug 2022 19:58
  
Thank you for your information
Newbie698456 Lv1Posted 19 Aug 2022 20:03
  
Thank you for your information
Newbie698456 Lv1Posted 19 Aug 2022 20:04
  
Thank you for your information
Kashif Mughal Lv1Posted 26 Aug 2022 13:47
  

Thank you for your information
Faisal P Posted 13 Sep 2022 16:48
  
Thank you very much for the information ...
Faisal P Posted 13 Sep 2022 16:49
  
Nice article ...

I want to write a case
Doc ID: 6394
Author: Sangfor_Siva
Updated: 2022-07-27 10:31
Version: