DHCP fail to work

|
  • 210
  • 12

Issue Description

The user has configured the DHCP, but the PC failed to get IP from NGAF.

Handling Process

1. Perform packet capture on the interface.
2. Check on the DHCP packet, found that PC has sent the DHCP Discover packets to NGAF but NGAF didn't reply.

3. Check on the system log, and found that there is an Error log generated.
Error Message: When Interface (ethx.x) is added to IP pool (x.x.x.x-x.x.x.x), total number of IP addresses exceed the maximum (10000). THis IP pool is banned from use.
4. Verify with support team that currently NGAF only support configure the IP pool up to 10000 IP address.

Root Cause

The IP pool of the DHCP exceeded 10000 IPs, causing the DHCP to fail to work.

Solution

Disable the DHCP service, and reduce the IP pool on the DHCP configuration.
Newbie191628 Lv3Posted 14 Jun 2022 09:59
  
Thanks for sharing
Raja Azkar Lv2Posted 15 Jun 2022 20:50
  
Thanks for sharing
Faisal P Posted 28 Jun 2022 10:32
  
  
Raza Islam Lv3Posted 04 Jul 2022 19:23
  
Thanks for sharing.
Raza Islam Lv3Posted 18 Jul 2022 20:52
  
Thank you very much for the information.
Naghmana Lv1Posted 19 Aug 2022 19:58
  
Thank you for your information
Kashif Mughal Lv1Posted 29 Aug 2022 19:54
  
Great Information
Faisal P Posted 15 Sep 2022 17:13
  
Thank you very much for the information ...
Faisal P Posted 15 Sep 2022 17:14
  
Nice article ...

I want to write a case
Doc ID: 6202
Author: KY
Updated: 2022-06-14 09:58
Version: