Sangfor Community»Categories Product WANO Dashboard Data Reduction Ratio Status Not Equal

Dashboard Data Reduction Ratio Status Not Equal

views: 13463 | comments: 6 | added to Favorites 0
Lights on | 提示:支持键盘翻页<-左 右->
    组图打开中,请稍候......
Created: 08 May 2018 23:26

Summary:

Last edited by yvest 08 May 2018 23:27. Question: Why after WOC Head office and Branch Dashboard Data Reduction Ratio status is not the same or nearly the same? although, upon checking on the "Acce ...

Reply

MChalidA Posted 16 Aug 2019 12:14
Go to navigation area > Wan Optimization > Byte cache and check If Maximize Data Reduction is selected, bandwidth savings will be maximized but throughput of
the WAN Optimization Controller (WOC) will be lowered down.
If Maximize LAN  Throughput is selected,  throughput of the WOC  will be maximized but  data
reduction capability will be affected.
CTI LS Posted 21 May 2018 15:50
Hi Yvest,

The reduction ratio from the page "Acceleration Connection" only calculate from the Acceleration Tunnel built up until current. If the Acceleration Tunnel is restarted, it will count starts from zero again. While the reduction ratio from the Home page "Acceleration Status" is sum up of the entire Traffic since day 1 until now even the Acceleration Tunnel is restarted.
CTI_MK Posted 10 May 2018 15:56
Hi Yvest,

Have you verified as well the data in the report center?
CTI_MK Posted 09 May 2018 18:22
Hi Yvest,

Normally the WANO traffic reduction = (equals to) WAN port traffic/LAN port traffic.
The network traffic pass through the HQ WANO and branch WANO  could be different (such as the Internet traffic flow through on both sides of the WANO may not be the same). Therefore, sometimes we will see different traffic reduction between HQ and branch.