NGAF and VLAN

jkia Lv1Posted 11 Feb 2020 11:50

Hi! I'd like to ask if this config is good to go or not. I'm going to use made up IP addresses for better understanding:

eth0 - LAN (192.168.2.1)
eth1 - WAN (Static IP - 10.0.20.130 | Next-Hop IP: 10.0.20.1)
eth2 - WAN2 (Static IP - 192.168.20.224 | Next-Hop IP: 192.168.20.1)
eth3 - WAN3 (Static IP - 172.31.20.2 | Next-Hop IP: 172.31.20.1)
eth0.10 - VLAN (Static IP: 192.168.1.1 | Next-Hop IP: 192.168.2.1)
eth0.20 - VLAN (Static IP: 192.168.100.1 | Next-Hop IP: 192.168.2.1)
eth0.30 - VLAN (Static IP: 192.168.10.1 | Next-Hop IP: 192.168.2.1)

The connections setup is:

ISP1 connected to eth1 of NGAF (L3 mode)
ISP2 connected to eth2 of NGAF (L3 mode)
ISP3 connected to eth3 of NGAF (L3 mode)
Managed Switch - eth0 of NGAF (L3 mode)

Any help/ suggestion is appreciated. Thanks!

Park Bo Gart has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Eth 0 doesn't need to have IP address configuration. And remove the next-hop IP for your vlan/subinterfaces.
Is this answer helpful?
addimasqi Lv2Posted 11 Feb 2020 12:44
  
can you explain, why you are using the VLAN / sub-interface? What is the purpose? Is it for your LAN (trusted network area) or anything else?
Park Bo Gart Lv2Posted 11 Feb 2020 13:16
  
Eth 0 doesn't need to have IP address configuration. And remove the next-hop IP for your vlan/subinterfaces.

I Can Help:

Change

Moderator on This Board

1
21
3

Started Topics

Followers

Follow

Board Leaders