rivsy Lv5Posted 06 Jun 2022 13:58
  
1. In the network interface, Click WAN link
2. On the bottom click Link state Detection Settings
3. Enable, then click PING and set Destination IP 1 (input gateway IP of ISP)
4. After Configuring Link state detection of your WAN Links
-  You can see the state of it if its Normal or at Fault
5. After setting the link state detection, Go to Network > Routing > Policy Based Routing then add Link Load
Balancing Route.
-  Network Objects > ALL
-  Add interface of WAN Links for failover

Please see below picture for reference of the steps

wan1.png (34.05 KB, Downloads: 426)

wan1.png

wan2.png (27.14 KB, Downloads: 431)

wan2.png

wan3.png (25.2 KB, Downloads: 423)

wan3.png

wan4.png (34.29 KB, Downloads: 430)

wan4.png

wan5.png (27.63 KB, Downloads: 425)

wan5.png

I Can Help:

Change

Moderator on This Board

1
131
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders