Imran Tahir Lv4Posted 07 Jun 2022 14:05
  
we have two links and we have configure link load balancing
1. In the network interface, Click WAN link
2. On the bottom click Link state Detection Settings
3. Enable, then click PING and set Destination IP 1 (input gateway IP of ISP)
4. After Configuring Link state detection of your WAN Links
-  You can see the state of it if its Normal or at Fault
5. After setting the link state detection, Go to Network > Routing > Policy Based Routing then add Link Load
Balancing Route.
-  Network Objects > ALL
-  Add interface of WAN Links for failover

Please see below picture for reference of the steps

wan1.png (34.05 KB, Downloads: 426)

wan1.png

wan2.png (27.14 KB, Downloads: 431)

wan2.png

wan3.png (25.2 KB, Downloads: 423)

wan3.png

wan4.png (34.29 KB, Downloads: 430)

wan4.png

wan5.png (27.63 KB, Downloads: 425)

wan5.png
Is this answer helpful?
Imran Tahir Lv4Posted 20 Jul 2022 19:32
  

Thank you for sharing

I Can Help:

Change

Moderator on This Board

1
131
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders