Newbie451055 Lv2Posted 14 Oct 2019 17:55
  
Hi Friend,

You need to configure the following steps :
1.  In the switch configuration, you need to change the switch port that connects to HCI into trunk port.  And allow only specific VLAN that you need.
2.  In HCI configuration, at Networking Tab, you have to creates 2 different switches, where each switch represents the VLAN that you need to connect.

After both steps above, you can choose to which VLAN does your VM want to connect, by choosing the correct switch.

I Can Help:

Change

Moderator on This Board

2
20
0

Started Topics

Followers

Follow

Board Leaders