Jo Lv2Posted 30 Jun 2020 14:57
  
I have the same issue on NGAF device. Updater unable to detect and also cannot ping. My solution is to configure the IP in the backend on the ports that haven't been assign IP yet.

ETH0 = 10.251.251.251
ETH1 = 192.168.1.10
ETH2 = 10.1.1.1
ETH3 = blank (configure ip on this using backend)

After that you configure your pc's ip to the same range then connect. It should be able to access the Web UI already(If hang then use Internet Explorer). After access the web UI never configure the ip on the new port. If you do, then the port will having the same problem with other port. Just reset to the factory defaults, then should be ok already.

I Can Help:

Change

Moderator on This Board

1
131
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders