Link load balance 2 WAN

Amirul Shazriel Lv1Posted 19 Jun 2019 15:50

Eth1 - 100Mbps (priority)
Eth2 - 200Mbps (backup)

Current method is using "Priority on top" as Eth1 as a priority link. If Eth1 already reach to max 100Mbps, is the NGAF will distribute the bandwidth to the Eth2 as backup ? since the method is running active-standby. From observation, the link will use Eth1 and only use Eth2 when link detection at Eth1 is failed.

ITD_Mitch has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Since your Method is "Priority on top" its always using your ETH1 bandwidth even if its maximum usage. If you want to use the ETH2, change your Method to "Round Robin" for active-active usage.
Is this answer helpful?
CTI Jimy Lv2Posted 20 Jun 2019 18:13
  
Hi,

We have notice that a case has been created for your issue. Kindly refer to your email.
Apriyanto Lv5Posted 26 Jun 2019 10:09
  
hope you get the solve immediately
ITD_Mitch Lv3Posted 08 Jul 2019 07:11
  
Since your Method is "Priority on top" its always using your ETH1 bandwidth even if its maximum usage. If you want to use the ETH2, change your Method to "Round Robin" for active-active usage.
Adit Reksa Lv2Posted 16 Jul 2019 23:56
  
prefer you can user failover , i hope helping you

I Can Help:

Change

Moderator on This Board

1
23
3

Started Topics

Followers

Follow

Board Leaders