How to Restore Factory Defaults IAM ? 10

Apriyanto Lv5Posted 09 May 2019 19:13

How to Restore Factory Defaults IAM ?

Explain Clearly

Muhammad Talha has solved this question and earned 30 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins, 10 coins of bounty and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

However if you don't remember your device username and password then you need to hard reset your device.
For that We can use a cross cable to restore factory defaults except by Updater,

The steps you need to follow are as follows:
Using the power button to shutdown the IAM device.
Prepared a cross cable.
Using the cross cable to connect to any two interfaces of  IAM device。(Attention: The two interface can't be bypass interfaces.)
Finally starting up the IAM device and waiting for 5 minutes.

Attentions:
1. On starting up the IAM device,you can see the red light on always,it means restoring factory defaults.Waiting for 3 minutes,the red light will flash,and keep waiting for 2 minutes, if  restore success,the IAM device will auto reboot,so you can use the default ip address to login the IAM.

2.After resotred factory defaults,all the configurations will be lost.

I hope this will help you out. Thanks and Regards
Is this answer helpful?
Muhammad Talha Posted 10 May 2019 01:29
  
Hi Dear,

If you know the device username and password, you login to your device, Go to Systems -> General -> Backup and Restore. From here you can restore your device to factory defaults
Muhammad Talha Posted 10 May 2019 01:31
  
However if you don't remember your device username and password then you need to hard reset your device.
For that We can use a cross cable to restore factory defaults except by Updater,

The steps you need to follow are as follows:
Using the power button to shutdown the IAM device.
Prepared a cross cable.
Using the cross cable to connect to any two interfaces of  IAM device。(Attention: The two interface can't be bypass interfaces.)
Finally starting up the IAM device and waiting for 5 minutes.

Attentions:
1. On starting up the IAM device,you can see the red light on always,it means restoring factory defaults.Waiting for 3 minutes,the red light will flash,and keep waiting for 2 minutes, if  restore success,the IAM device will auto reboot,so you can use the default ip address to login the IAM.

2.After resotred factory defaults,all the configurations will be lost.

I hope this will help you out. Thanks and Regards
Apriyanto Lv5Posted 13 May 2019 12:42
  
nobody answer except talha hahaha , thanks bro

I Can Help:

Change

Moderator on This Board

11
36
1

Started Topics

Followers

Follow

3
3
3

Started Topics

Followers

Follow

Board Leaders