Replication with Veeam

Newbie007306 Lv1Posted Jan-14-2025 19:32

Hello,
is it possible to use "Veeam Backup & Replication" to make a replica of a VM between two nodes running Sangfor HCI?

AimanHakim has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Hi, actually Sangfor supports Veam. It's just that in the previous version 6.9.0 and below I believe the system did not officially declare the it supports Veam. In the latest version 6.10.0 has declared it does support and you'll just need to allow it under the ports management. So yes u can use Veam to make a replica from node 1 to node 2.

If the scenario is that 2 nodes running independently, the replication will use the management interface to communicate between the 2 nodes.
Is this answer helpful?
Rumzell Lv1Posted Jan-16-2025 09:37
  
Using Veeam Backup & Replication to create a replica of a virtual machine (VM) between two nodes running Sangfor HCI is not natively supported out of the box. Veeam primarily supports environments based on VMware vSphere, Microsoft Hyper-V, and Nutanix AHV for backup and replication tasks.
Sangfor HCI uses its proprietary hypervisor, which is not officially supported by Veeam

I Can Help:

Change

Board Leaders

NyxZale...

Weekly Sharers

Newbie5...

Weekly Questioners