Sangfor ES Syslog

pbeugenio Lv1Posted 14 Nov 2024 10:50

How can I enable the syslog on Sangfor  ES 6.0.4 that is in SaaS?

admin has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

enabling or modifying syslog settings on Sangfor ES 6.0.4 (SaaS) may require assistance from Sangfor's technical support team at tech.support@sangfor.com. The specific issue mentioned involves changing the syslog protocol from TCP to UDP, which also necessitates remote troubleshooting by engineers.
Is this answer helpful?
Zonger Lv5Posted 14 Nov 2024 11:13
  
To enable Syslog on Sangfor ES version 6.0.4 in a SaaS environment, log in to the Sangfor ES Web Management Interface as an administrator, then navigate to **System Settings** > **Log Settings**. In the Log Settings section, locate the Syslog configuration options, where you can enable the Syslog feature. Enter the Syslog server's IP address, specify the port (default is usually 514 for UDP), and choose the log level you wish to send (e.g., Information, Warning, Error). After configuring these settings, save and apply the changes.
admin Posted 14 Nov 2024 11:44
  
enabling or modifying syslog settings on Sangfor ES 6.0.4 (SaaS) may require assistance from Sangfor's technical support team at tech.support@sangfor.com. The specific issue mentioned involves changing the syslog protocol from TCP to UDP, which also necessitates remote troubleshooting by engineers.
Rotring Lv2Posted 14 Nov 2024 12:03
  
HI
enable syslog on Sangfor ES 6.0.4, you can typically follow these steps:
  • Log into Sangfor ES SaaS Console: Access the Sangfor ES SaaS interface with your administrator credentials.
  • Go to System Settings:

    • From the main dashboard, navigate to System Settings or Configuration.

  • Locate the Syslog Settings:

    • Look for Syslog or Log Management options within the system settings.
    • In some versions, you might find syslog settings under Maintenance or Logging.

  • Configure the Syslog Server:

    • Add the IP address or hostname of your external syslog server.
    • Specify the syslog port, commonly port 514 for UDP or TCP, depending on your syslog server setup.
    • Select the log level (such as Informational, Warning, or Error) to determine which types of logs will be sent to the syslog server.
    • Optionally, set a facility level (if Sangfor ES allows it), which helps identify the log source.

  • Enable Syslog and Save Settings:

    • Enable syslog by selecting an Enable checkbox or a similar toggle.
    • Apply or save the configuration settings.

  • Test Connectivity:

    • Check if logs are being sent to the syslog server by monitoring your syslog server for incoming logs from Sangfor ES.

I Can Help:

Change

Moderator on This Board

3
14
3

Started Topics

Followers

Follow

43
2
2

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

7
11
4

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Trending Topics

Board Leaders