Dears,
May we have the installation menu of Sangfor firewall NSF-3100A-I?
How to config Threat Intelligence?
How to config IoT?
Please advise if any video about NSF-3100A-I?

Thx a lot!

Newbie517762 has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

HiHi,

Depending on your deployment or usage, please find below a wealth of NGAF information for your study and reference:
h__ps://community.sangfor.com/forum.php?mod=viewthread&tid=3400
Is this answer helpful?
Newbie517762 Lv5Posted 05 Nov 2024 12:24
  
HiHi,

Depending on your deployment or usage, please find below a wealth of NGAF information for your study and reference:
h__ps://community.sangfor.com/forum.php?mod=viewthread&tid=3400
Jackal Tang Lv1Posted 05 Nov 2024 13:15
  
Hihi,

For the new NSF-3100A-I firewall, is that use firmware version 8.0.85 now?
Is this stable now?

Thx a lot!
Farina Ahmed Lv5Posted 05 Nov 2024 13:46
  
To configure the Sangfor NSF-3100A-I firewall, start by accessing the web management interface using a browser, then proceed with initial setup through the wizard. For configuring Threat Intelligence, navigate to Security > Threat Intelligence, and enable the relevant options to enhance detection and response to emerging threats. To configure IoT, go to IoT > Device Discovery, enabling automatic detection of IoT devices on your network and setting policies based on device types.
Jackal Tang Lv1Posted 05 Nov 2024 14:01
  
For the new NSF-3100A-I firewall, is that use firmware version 8.0.85 now?
Is this stable now?

Thx a lot!
Jackal Tang Lv1Posted 05 Nov 2024 14:50
  
Well noted, thx a lot
AR Lv1Posted 05 Nov 2024 18:37
  
Hello. Start by using a browser to visit the web management interface, then follow the wizard's instructions to complete the initial configuration of the Sangfor NSF-3100A-I firewall. To improve detection and reaction to new threats, configure Threat Intelligence by going to Security > Threat Intelligence and turning on the appropriate settings. Go to IoT > Device Discovery to configure IoT, allowing automatic device identification on your network and establishing device-type-based policies.

I Can Help:

Change

Moderator on This Board

11
7
5

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
137
3

Started Topics

Followers

Follow

Board Leaders