Iam 11.6.1 password reset

Newbie754636 Lv1Posted 01 Sep 2024 20:16

I have old sangfor m5100 with iam 11.6.1, i already do factory reset with cross cable, but the default user/password won't work it's say "can not match policy" Anyone can help?

17251929853853122220168165739086.jpg (81.61 KB, Downloads: 18)

17251929853853122220168165739086.jpg

By solving this question, you may help 539 user(s).

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Enrico Vanzetto Lv4Posted 01 Sep 2024 22:10
  
Hi, have you already tried this procedure?

Access the Reset Page: Open your browser and go to https://[IAM_IP]/php/rp.php. This will create a file and prompt you to plug in a crossover cable and restart the device.
Disconnect Other Cables: Unplug any other cables connected to the IAM device.
Connect Crossover Cable: Plug a crossover cable into two non-bypass interfaces on the IAM device (e.g., eth0-eth2, eth1-eth3).
Restart the Device: Restart the IAM device.
Wait and Login: Wait for about 10 minutes, then you can log in using the default credentials admin/admin
Newbie517762 Lv5Posted 02 Sep 2024 09:08
  
HiHi,

Please find the attached file on 'How to Recover Default Password' for your reference.
Recover Default Password.pdf (356.87 KB, Downloads: 17)
Imran Tahir Lv4Posted 02 Sep 2024 12:10
  
Through USB
Zonger Lv5Posted 02 Sep 2024 14:10
  
Please check if the default policy has not been modified or overridden. You can check this by resetting the default policy by logging in to the device using a cross cable connection and navigating to System Management > Policy > Default Policy > Reset to Default. This will restore the default policy and allow you to access the device with the default user and password.

I Can Help:

Change

Moderator on This Board

15
24
3

Started Topics

Followers

Follow

1
1
5

Started Topics

Followers

Follow

Board Leaders