Best Pratice VLAN and Bridge in NGAF

rohmattullah Lv1Posted 26 Aug 2024 15:36

Hi Everyone!

I want to change my topology with VLAN and Bridge in port NGAF. Is configuration same with another router like mikrotik and cisco?

fyi, i use switch managed Ubiquiti to manage trunk of VLAN

fuadmahbubun has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Last edited by fuadmahbubun 26 Aug 2024 16:11.

Hi, create vlan and bridge in NGAF almost same with another router or switch.
but in sangfor NGAF you may create it based on interface type layer 2 or layer3.

please follow guidance in this topic,

https://community.sangfor.com/fo ... 2&page=1#/pid180700
Is this answer helpful?
fuadmahbubun Lv2Posted 26 Aug 2024 16:09
  
Last edited by fuadmahbubun 26 Aug 2024 16:11.

Hi, create vlan and bridge in NGAF almost same with another router or switch.
but in sangfor NGAF you may create it based on interface type layer 2 or layer3.

please follow guidance in this topic,

https://community.sangfor.com/fo ... 2&page=1#/pid180700
Farina Ahmed Lv5Posted 26 Aug 2024 18:17
  
On an NGAF, you'll typically need to configure VLANs on the firewall interfaces, set up bridge groups if necessary, and ensure proper trunking on the switch (Ubiquiti) for VLAN tagging.
Zonger Lv5Posted 28 Aug 2024 22:31
  
For Ubiquiti managed switches, you'll need to configure the VLAN trunking on the switch itself, and then configure the VLAN and bridge settings on the Sangfor NGAF.

1. Configure the VLAN trunking on the Ubiquiti switch:
        * Create a VLAN trunk on the switch and assign the desired VLAN IDs to it.
        * Configure the switch to send tagged VLAN frames to the Sangfor NGAF.
2. Configure the VLAN settings on the Sangfor NGAF:
        * Create a VLAN interface on the Sangfor NGAF for each VLAN ID you want to use.
        * Configure the VLAN interface to use the corresponding VLAN ID.
3. Configure the bridge settings on the Sangfor NGAF:
        * Create a bridge on the Sangfor NGAF and add the VLAN interfaces to it.
        * Configure the bridge settings as needed (e.g., bridge mode, IP address, etc.).

I Can Help:

Change

Moderator on This Board

11
3
4

Started Topics

Followers

Follow

1
1
5

Started Topics

Followers

Follow

0
2
4

Started Topics

Followers

Follow

67
17
3

Started Topics

Followers

Follow

3
5
3

Started Topics

Followers

Follow

1
135
3

Started Topics

Followers

Follow

Board Leaders