problem port forwarding

Newbie098595 Lv1Posted 2024-Jul-16 11:08

i have a problem , i just config port forwarding from private IP to Publik Ip , when I try to access from outside network ,forwarding port can access but , from inside ngaf the forwarding can not access , is that something filter I need to accept for solved this issue ?

Thank you

fuadmahbubun has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Last edited by fuadmahbubun 22 Jul 2024 16:29.

Hi, make sure your packet data is correct and set network access policy for NAT's Rule.

the points for NAT are source zone, source address, destination zone and destination address.
here some example for NAT.

for complete guidance you may check this article

https://knowledgebase.sangfor.com/detailPage?articleData=%7B%22articleType%22%3A1,%22articleId%22%3A%226de9ccc724194294a5ea5995cc578720%22,%22keyword%22%3A%22%22%7D







This topic contains more resources

You must log in to download or view the file. Not registered yet? Register

x
Is this answer helpful?
CLELUQMAN Lv4Posted 2024-Jul-17 09:00
  
hi,
1. can u provide a simple diagram of your network topology
2. can share screenshot of your NAT policy
Enrico Vanzetto Lv4Posted 2024-Jul-17 15:54
  
Hi, the resorces that you try to access from internal network is on a different network segment (different vlan)? Try to perform a precise traffic analysis on ngaf's web ui (navigate to System -> troubleshooting) and fill out the source and destination ip. Then start precise traffic analysis and perform some test traffic to your itnernal resoucres that you are trying to reach.
fuadmahbubun Lv2Posted 2024-Jul-22 16:27
  
Last edited by fuadmahbubun 22 Jul 2024 16:29.

Hi, make sure your packet data is correct and set network access policy for NAT's Rule.

the points for NAT are source zone, source address, destination zone and destination address.
here some example for NAT.

for complete guidance you may check this article

https://knowledgebase.sangfor.com/detailPage?articleData=%7B%22articleType%22%3A1,%22articleId%22%3A%226de9ccc724194294a5ea5995cc578720%22,%22keyword%22%3A%22%22%7D







This topic contains more resources

You must log in to download or view the file. Not registered yet? Register

x

I Can Help:

Change

Moderator on This Board

11
8
5

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
138
3

Started Topics

Followers

Follow

Board Leaders